drivers/net: Trim trailing whitespace

Signed-off-by: Jeff Garzik <jeff@garzik.org>
This commit is contained in:
Jeff Garzik
2006-09-13 13:24:59 -04:00
parent 7a29108322
commit 6aa20a2235
178 changed files with 22402 additions and 22402 deletions

View File

@ -65,7 +65,7 @@
* 0.20 - fix stupid RFEN thinko. i am such a smurf.
* 20040828 0.21 - add hardware vlan accleration
* by Neil Horman <nhorman@redhat.com>
* 20050406 0.22 - improved DAC ifdefs from Andi Kleen
* 20050406 0.22 - improved DAC ifdefs from Andi Kleen
* - removal of dead code from Adrian Bunk
* - fix half duplex collision behaviour
* Driver Overview
@ -377,7 +377,7 @@ static int lnksts = 0; /* CFG_LNKSTS bit polarity */
#define LINK_DOWN 0x02
#define LINK_UP 0x04
#define HW_ADDR_LEN sizeof(dma_addr_t)
#define HW_ADDR_LEN sizeof(dma_addr_t)
#define desc_addr_set(desc, addr) \
do { \
((desc)[0] = cpu_to_le32(addr)); \
@ -493,7 +493,7 @@ static inline void kick_rx(struct net_device *ndev)
(((NR_TX_DESC-2 + dev->tx_done_idx - dev->tx_free_idx) % NR_TX_DESC) > MIN_TX_DESC_FREE)
#ifdef NS83820_VLAN_ACCEL_SUPPORT
#ifdef NS83820_VLAN_ACCEL_SUPPORT
static void ns83820_vlan_rx_register(struct net_device *ndev, struct vlan_group *grp)
{
struct ns83820 *dev = PRIV(ndev);
@ -865,7 +865,7 @@ static void fastcall ns83820_rx_kick(struct net_device *ndev)
}
/* rx_irq
*
*
*/
static void FASTCALL(rx_irq(struct net_device *ndev));
static void fastcall rx_irq(struct net_device *ndev)
@ -921,14 +921,14 @@ static void fastcall rx_irq(struct net_device *ndev)
* that are 64 bytes with a vlan header appended
* like arp frames, or pings, are flagged as Runts
* when the tag is stripped and hardware. This
* also means that the OK bit in the descriptor
* also means that the OK bit in the descriptor
* is cleared when the frame comes in so we have
* to do a specific length check here to make sure
* the frame would have been ok, had we not stripped
* the tag.
*/
*/
if (likely((CMDSTS_OK & cmdsts) ||
((cmdsts & CMDSTS_RUNT) && len >= 56))) {
((cmdsts & CMDSTS_RUNT) && len >= 56))) {
#else
if (likely(CMDSTS_OK & cmdsts)) {
#endif
@ -945,7 +945,7 @@ static void fastcall rx_irq(struct net_device *ndev)
skb->ip_summed = CHECKSUM_NONE;
}
skb->protocol = eth_type_trans(skb, ndev);
#ifdef NS83820_VLAN_ACCEL_SUPPORT
#ifdef NS83820_VLAN_ACCEL_SUPPORT
if(extsts & EXTSTS_VPKT) {
unsigned short tag;
tag = ntohs(extsts & EXTSTS_VTG_MASK);
@ -1047,7 +1047,7 @@ static void do_tx_done(struct net_device *ndev)
dev_kfree_skb_irq(skb);
atomic_dec(&dev->nr_tx_skbs);
} else
pci_unmap_page(dev->pci_dev,
pci_unmap_page(dev->pci_dev,
addr,
len,
PCI_DMA_TODEVICE);
@ -1359,8 +1359,8 @@ static void ns83820_do_isr(struct net_device *ndev, u32 isr)
dev->tx_idx = 0;
}
/* The may have been a race between a pci originated read
* and the descriptor update from the cpu. Just in case,
* kick the transmitter if the hardware thinks it is on a
* and the descriptor update from the cpu. Just in case,
* kick the transmitter if the hardware thinks it is on a
* different descriptor than we are.
*/
if (dev->tx_idx != dev->tx_free_idx)
@ -1388,8 +1388,8 @@ static void ns83820_do_isr(struct net_device *ndev, u32 isr)
/* The TxIdle interrupt can come in before the transmit has
* completed. Normally we reap packets off of the combination
* of TxDesc and TxIdle and leave TxOk disabled (since it
* occurs on every packet), but when no further irqs of this
* of TxDesc and TxIdle and leave TxOk disabled (since it
* occurs on every packet), but when no further irqs of this
* nature are expected, we must enable TxOk.
*/
if ((ISR_TXIDLE & isr) && (dev->tx_done_idx != dev->tx_free_idx)) {
@ -1956,7 +1956,7 @@ static int __devinit ns83820_init_one(struct pci_dev *pci_dev, const struct pci_
/* When compiled with 64 bit addressing, we must always enable
* the 64 bit descriptor format.
*/
if (sizeof(dma_addr_t) == 8)
if (sizeof(dma_addr_t) == 8)
dev->CFG_cache |= CFG_M64ADDR;
if (using_dac)
dev->CFG_cache |= CFG_T64ADDR;
@ -1994,7 +1994,7 @@ static int __devinit ns83820_init_one(struct pci_dev *pci_dev, const struct pci_
writel(dev->CFG_cache, dev->base + CFG);
}
#if 0 /* Huh? This sets the PCI latency register. Should be done via
#if 0 /* Huh? This sets the PCI latency register. Should be done via
* the PCI layer. FIXME.
*/
if (readl(dev->base + SRR))
@ -2006,7 +2006,7 @@ static int __devinit ns83820_init_one(struct pci_dev *pci_dev, const struct pci_
* can be transmitted is 8192 - FLTH - burst size.
* If only the transmit fifo was larger...
*/
/* Ramit : 1024 DMA is not a good idea, it ends up banging
/* Ramit : 1024 DMA is not a good idea, it ends up banging
* some DELL and COMPAQ SMP systems */
writel(TXCFG_CSI | TXCFG_HBI | TXCFG_ATP | TXCFG_MXDMA512
| ((1600 / 32) * 0x100),
@ -2020,8 +2020,8 @@ static int __devinit ns83820_init_one(struct pci_dev *pci_dev, const struct pci_
/* Set Rx to full duplex, don't accept runt, errored, long or length
* range errored packets. Use 512 byte DMA.
*/
/* Ramit : 1024 DMA is not a good idea, it ends up banging
* some DELL and COMPAQ SMP systems
/* Ramit : 1024 DMA is not a good idea, it ends up banging
* some DELL and COMPAQ SMP systems
* Turn on ALP, only we are accpeting Jumbo Packets */
writel(RXCFG_AEP | RXCFG_ARP | RXCFG_AIRL | RXCFG_RX_FD
| RXCFG_STRIPCRC
@ -2045,7 +2045,7 @@ static int __devinit ns83820_init_one(struct pci_dev *pci_dev, const struct pci_
* also turn on tag stripping if hardware acceleration is enabled
*/
#ifdef NS83820_VLAN_ACCEL_SUPPORT
#define VRCR_INIT_VALUE (VRCR_IPEN|VRCR_VTDEN|VRCR_VTREN)
#define VRCR_INIT_VALUE (VRCR_IPEN|VRCR_VTDEN|VRCR_VTREN)
#else
#define VRCR_INIT_VALUE (VRCR_IPEN|VRCR_VTDEN)
#endif