arm64: add early_ioremap support

Add support for early IO or memory mappings which are needed before the
normal ioremap() is usable.  This also adds fixmap support for permanent
fixed mappings such as that used by the earlyprintk device register
region.

Signed-off-by: Mark Salter <msalter@redhat.com>
Acked-by: Catalin Marinas <catalin.marinas@arm.com>
Cc: Borislav Petkov <borislav.petkov@amd.com>
Cc: Dave Young <dyoung@redhat.com>
Cc: H. Peter Anvin <hpa@zytor.com>
Cc: Will Deacon <will.deacon@arm.com>
Cc: Ingo Molnar <mingo@elte.hu>
Cc: Thomas Gleixner <tglx@linutronix.de>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>

arch/arm64/kernel/head.S

@@ -404,7 +404,7 @@ ENDPROC(__calc_phys_offset)
  *   - identity mapping to enable the MMU (low address, TTBR0)
  *   - first few MB of the kernel linear mapping to jump to once the MMU has
  *     been enabled, including the FDT blob (TTBR1)
- *   - UART mapping if CONFIG_EARLY_PRINTK is enabled (TTBR1)
+ *   - pgd entry for fixed mappings (TTBR1)
  */
 __create_page_tables:
 	pgtbl	x25, x26, x24			// idmap_pg_dir and swapper_pg_dir addresses
@@ -461,15 +461,12 @@ __create_page_tables:
 	sub	x6, x6, #1			// inclusive range
 	create_block_map x0, x7, x3, x5, x6
 1:
-#ifdef CONFIG_EARLY_PRINTK
 	/*
-	 * Create the pgd entry for the UART mapping. The full mapping is done
-	 * later based earlyprintk kernel parameter.
+	 * Create the pgd entry for the fixed mappings.
 	 */
-	ldr	x5, =EARLYCON_IOBASE		// UART virtual address
+	ldr	x5, =FIXADDR_TOP		// Fixed mapping virtual address
 	add	x0, x26, #2 * PAGE_SIZE		// section table address
 	create_pgd_entry x26, x0, x5, x6, x7
-#endif
 	ret
 ENDPROC(__create_page_tables)
 	.ltorg