linux-kernel-test/arch/arm/mach-omap2/sdrc.c
Kevin Hilman 8bd2294922 OMAP2/3: PM: push core PM code from linux-omap
This patch is to sync the core linux-omap PM code with mainline.  This
code has evolved and been used for a while the linux-omap tree, but
the attempt here is to finally get this into mainline.

Following this will be a series of patches from the 'PM branch' of the
linux-omap tree to add full PM hardware support from the linux-omap
tree.

Much of this PM core code was written by Jouni Hogander with
significant contributions from Paul Walmsley as well as many others
from Nokia, Texas Instruments and linux-omap community.

Signed-off-by: Jouni Hogander <jouni.hogander@nokia.com>
Cc: Paul Walmsley <paul@pwsan.com>
Signed-off-by: Kevin Hilman <khilman@deeprootsystems.com>
2009-05-28 10:58:50 -07:00

114 lines
2.8 KiB
C

/*
* SMS/SDRC (SDRAM controller) common code for OMAP2/3
*
* Copyright (C) 2005, 2008 Texas Instruments Inc.
* Copyright (C) 2005, 2008 Nokia Corporation
*
* Tony Lindgren <tony@atomide.com>
* Paul Walmsley
* Richard Woodruff <r-woodruff2@ti.com>
*
* This program is free software; you can redistribute it and/or modify
* it under the terms of the GNU General Public License version 2 as
* published by the Free Software Foundation.
*/
#undef DEBUG
#include <linux/module.h>
#include <linux/kernel.h>
#include <linux/device.h>
#include <linux/list.h>
#include <linux/errno.h>
#include <linux/delay.h>
#include <linux/clk.h>
#include <linux/io.h>
#include <mach/common.h>
#include <mach/clock.h>
#include <mach/sram.h>
#include "prm.h"
#include <mach/sdrc.h>
#include "sdrc.h"
static struct omap_sdrc_params *sdrc_init_params;
void __iomem *omap2_sdrc_base;
void __iomem *omap2_sms_base;
/* SDRC_POWER register bits */
#define SDRC_POWER_EXTCLKDIS_SHIFT 3
#define SDRC_POWER_PWDENA_SHIFT 2
#define SDRC_POWER_PAGEPOLICY_SHIFT 0
/**
* omap2_sdrc_get_params - return SDRC register values for a given clock rate
* @r: SDRC clock rate (in Hz)
*
* Return pre-calculated values for the SDRC_ACTIM_CTRLA,
* SDRC_ACTIM_CTRLB, SDRC_RFR_CTRL, and SDRC_MR registers, for a given
* SDRC clock rate 'r'. These parameters control various timing
* delays in the SDRAM controller that are expressed in terms of the
* number of SDRC clock cycles to wait; hence the clock rate
* dependency. Note that sdrc_init_params must be sorted rate
* descending. Also assumes that both chip-selects use the same
* timing parameters. Returns a struct omap_sdrc_params * upon
* success, or NULL upon failure.
*/
struct omap_sdrc_params *omap2_sdrc_get_params(unsigned long r)
{
struct omap_sdrc_params *sp;
if (!sdrc_init_params)
return NULL;
sp = sdrc_init_params;
while (sp->rate && sp->rate != r)
sp++;
if (!sp->rate)
return NULL;
return sp;
}
void __init omap2_set_globals_sdrc(struct omap_globals *omap2_globals)
{
omap2_sdrc_base = omap2_globals->sdrc;
omap2_sms_base = omap2_globals->sms;
}
/**
* omap2_sdrc_init - initialize SMS, SDRC devices on boot
* @sp: pointer to a null-terminated list of struct omap_sdrc_params
*
* Turn on smart idle modes for SDRAM scheduler and controller.
* Program a known-good configuration for the SDRC to deal with buggy
* bootloaders.
*/
void __init omap2_sdrc_init(struct omap_sdrc_params *sp)
{
u32 l;
l = sms_read_reg(SMS_SYSCONFIG);
l &= ~(0x3 << 3);
l |= (0x2 << 3);
sms_write_reg(l, SMS_SYSCONFIG);
l = sdrc_read_reg(SDRC_SYSCONFIG);
l &= ~(0x3 << 3);
l |= (0x2 << 3);
sdrc_write_reg(l, SDRC_SYSCONFIG);
sdrc_init_params = sp;
/* XXX Enable SRFRONIDLEREQ here also? */
l = (1 << SDRC_POWER_EXTCLKDIS_SHIFT) |
(1 << SDRC_POWER_PWDENA_SHIFT) |
(1 << SDRC_POWER_PAGEPOLICY_SHIFT);
sdrc_write_reg(l, SDRC_POWER);
}